SATA 1/2'' Stecknuss- und Schlagschrauber-Set mit max. 660 Nm und 8 Stecknüssen

Es recomana utilitzar un compressor que proporcioni entre 6 i 8 bar (600–800 kPa) de pressió constant, amb un cabal mínim suggerit de 110 l/min, i connexió de mànega de 1/4" NPT. Compressors per sota d’aquest rang poden provocar pèrdua de parell i reducció de la vida útil.

El manteniment principal consisteix a aplicar unes gotes d’oli pneumàtic a l’entrada d’aire abans de cada ús per evitar corrosió i desgast intern. També és important mantenir l’eina neta, revisar periòdicament les juntes i assegurar-se de no excedir la pressió màxima permesa.

El fabricant generalment ofereix una garantia limitada coberta contra defectes de materials o fabricació (subjecta a les condicions locals del distribuïdor). Els vasos de 1/2" són peces estàndard, de manera que es poden trobar recanvis compatibles fàcilment en comerços especialitzats.

It is recommended to use a compressor providing between 6 and 8 bar (600–800 kPa) of constant pressure, with a suggested minimum flow rate of 110 l/min, and a 1/4" NPT hose connection. Compressors below this range may cause loss of torque and reduced service life.

The main maintenance task is to apply a few drops of pneumatic oil to the air inlet before each use to prevent corrosion and internal wear. It is also important to keep the tool clean, check the seals periodically and ensure the maximum permitted pressure is not exceeded.

The manufacturer generally offers a limited warranty covering defects in materials or workmanship (subject to the distributor's local conditions). 1/2" sockets are standard parts, so compatible replacements can be found easily from specialist retailers.

It is recommended to use a compressor that provides between 6 and 8 bar (600–800 kPa) of constant pressure, with a suggested minimum flow rate of 110 l/min, and a 1/4" NPT hose connection. Compressors below this range may cause loss of torque and reduced service life.

The main maintenance is to apply a few drops of pneumatic oil to the air inlet before each use to prevent corrosion and internal wear. It is also important to keep the tool clean, check the seals periodically and make sure not to exceed the maximum permitted pressure.

The manufacturer generally offers a limited warranty covering defects in materials or workmanship (subject to the local distributor's conditions). The 1/2" sockets are standard parts, so compatible replacements can be found easily from specialist retailers.

Det rekommenderas att använda en kompressor som ger mellan 6 och 8 bar (600–800 kPa) konstant tryck, med ett minsta rekommenderat flöde på 110 l/min och slanganslutning 1/4" NPT. Kompressorer under detta intervall kan orsaka förlorat vridmoment och kortare livslängd.